Reverse engineering of electronic boards
Reverse engineering and copying of electronic boards from two to sixteen layers is done by experienced specialists using advanced tools. The most important steps of PCB reverse engineering are as follows
-
First step: the parts on the board are identified and the BOM of the parts is extracted and the technical specifications of each part are determined.
-
Second step: PCB and Gerber files are extracted in different layers using very accurate and reliable hardware and software tools.
-
Third step: Using the PCB file and BOM of the parts, the schematic of the board is extracted.
-
Fourth step: Finally, the board sample is made and after assembly, it will be provided to the customer.
extracted and the technical
extracted in different layers
electronic board extracte
board sample make
Electronic designers in the technical group, relying on ten years of experience and up-to-date knowledge in the design and analysis of electronic circuits according to the order, provide the following services in the design and manufacture of electronic boards.
-
PCB drawing, schematic, Gerber in two to sixteen layers
-
Board printing in different materials, thicknesses and coatings
-
Board assembly with manual and automatic methods
-
Performing Electro Magnetic, Signal Integrity, Power Integrity and Thermal analysis
-
Performing functional and environmental tests in accredited laboratories
-
Design and manufacture of box and mechanical board protection